[T10] A question about the condition of Transition SP15, hope to receive your reply. Thankyou.

[Guojian (F)]

Hi T10 ORG,

I have a question about the condition of Transition SP15.
If optical mode is enabled, and the SP state machine is in SP15 with negation speed is 3Gbps. When the other side send COMINIT using 3Gbps rate, the DWS reset message will not be generated.
Then should the SP state machine transmit from SP15 to SP0?
Hope to receive your reply! Thank you!

Guojian


Description in SAS3.0 protocol:
5.12.4.10.2 Transition SP15:SAS_PHY_Ready to SP0:OOB_COMINIT
If optical mode is enabled or D.C. mode is enabled, then this transition shall occur after receiving:
a) a DWS Lost message, if this state does not send a Start DWS message;
b) a DWS Lost message followed by a COMINIT Detected message, if this state does not send a Start
DWS message; or
c) a DWS Reset message.
If optical mode is enabled, then this transition shall not occur after receiving a COMINIT Detected message:
a) before receiving a DWS Lost message; or
b) after sending a Start DWS message.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.t10.org/pipermail/t10/attachments/20160904/ec7f2d4d/attachment.html>