SAS Phy plenary minutes item

Paul Coddington paul.coddington at
Tue Jan 27 14:11:11 PST 2015

Formatted message: <a href="">HTML-formatted message</a>

Hi Joe,
In the SAS PHY WG Minutes, in the section entitled "3.4 SlimLine Internal
Connector proposal for inclusion to SAS-4 (15-015r1) [McSorley]", the last
line states "... the motion passed for recommendation to the plenary of
inclusion in SAS-4 of 15-015r0 as modified." The "as modified" means that
some corrections were made. This was because original document, 15-015r0, was
the one posted prior to and it was the one shown at the SAS PHY meeting.
However, at the meeting it was noted that there was an error in the document
in regards to the pin assignment table. Document 15-015r0 had the Tx & Rx
lanes numbered 1, 2, 3, & 4. These were corrected in 15-015r1 to be numbered
0, 1, 2, & 3 as is the common practice for SAS.
Best regards,
Paul P. Coddington
Interconnect Design Engineer
Amphenol High Speed Interconnects
A Division of Amphenol Corporation
20 Valley Street, Endicott, NY 13760<http">http://<><http://;/
From: owner-t10 at [mailto:owner-t10 at] On Behalf Of Joe Breher
Sent: Tuesday, January 27, 2015 4:35 PM
To: T10 Reflector
Subject: SAS Phy plenary minutes item
I am trying to square the SAS Phy minutes (15-039r0) with the Plenary minutes
It appears that the SAS Phy WG voted to ask the Plenary to approve 15-015r1
for inclusion into SAS-4. However, the Plenary minutes indicate that T10
voted to approve 15-015r0.
Joe Breher
(478) 2-Breher
(478) 227-3437
This e-mail may contain confidential or legally privileged information of
HGST. If you are not the intended recipient, please notify us immediately by
responding to this e-mail and then deleting it from your system.

More information about the T10 mailing list