[MtFuji] SATA cabcon proposal for Zero Power ODD effort

keiji_katata at post.pioneer.co.jp keiji_katata at post.pioneer.co.jp
Tue Aug 25 23:04:46 PDT 2009


* From the T10 Reflector (t10 at t10.org), posted by:
* keiji_katata at post.pioneer.co.jp
*
Hi Brian,
I have two reports and one comment from Pioneer.
Report #1:
 Pioneer had three type of loading system for slim drive.
 a. Tray/Drawer loading with eject button (for windows, linux)
 b. Slot loading with eject button (for windows, linux)
 c. Slot loading without eject button (for Mac)
Report #2:
 Type c system used similar system to Device Attention. But its signaling was
opposite.
 (This is just a report. Pioneer has no opinion.)
Comment:
 I think Slot loading with eject button should be considered in this
proposal.
Best regards,
Keiji Katata
PIONEER CORP.
"Leete, Brian A" <brian.a.leete at intel.com>@avc-pioneer.com on 2009/08/20
08:25:45
mtfuji5 at avc-pioneer.com$B$KJV?.$7$F$/$@$5$$(B
$BAw?.<T(B:	  owner-mtfuji5 at avc-pioneer.com
$B08 at h(B:  "cabcon at sata-io.org" <cabcon at sata-io.org>,
"mtfuji5 at avc-pioneer.com"
       <mtfuji5 at avc-pioneer.com>
cc:
$B7oL>(B:  [MtFuji] SATA cabcon proposal for Zero Power ODD effort
Mt Fuji/T10 MMC group
The SATA Cabcon group has been working on a modification to the slimline
connector to allow the host to power off an unused optical drive. At this
point
the changes are mature enough that we would request feedback from the optical
drive community on the proposal before completing the proposal and presenting
it
to the SATA board for approval.
This proposal contains changes to the existing SATA 3.0 specification. Red
font
is used to indicate changes, strikethrough indicates a deletion from the SATA
spec. Red font without a strikethrough indicates an addition to the
specification.
Feedback is welcome, and if it$B!G(Bs valuable to schedule a joint
Fuji/T10/Cabcon
meeting that can be arranged as well.
Brian Leete
CO5-166
Intel Corporation
1365 NW Amberglen Parkway
Beaverton, Oregon, 97006
503-456-0484
[TPR_C102_V04.doc]
*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org



More information about the T10 mailing list