Error in new power conditions model section

[Ralph Weber]

Formatted message: <a href="http://www.t10.org/cgi-bin/ac.pl?t=r&f=r0904152_f.htm">HTML-formatted message</a>

Under these circumstances, I do not feel comfortable making
the change as an editorial correction.
All the best,
.Ralph
Kevin_Marks at Dell.com wrote:
>
> I believe your text is still incorrect, as it is unclear whether the 
> "expect the REQUEST SENSE command" applies to both reinitialized and 
> start or just reinitialized.	My reading would say both, which is not 
> correct.
>
>  
>
> If any power condition timer in the Power Condition mode page is 
> enabled, then that timer shall be stopped on receipt of a command. On 
> completion of the command:
>
> 1)	 if the command was not a REQUEST SENSE command (see 6.29) then, 
>  all enabled timers shall be reinitialized based on their Power 
> Condition mode page values ; and
>
> 2)	 all enabled timers shall be started.
>
>  
>
> Kevin
>
>  
>
>  
>
> *From:* owner-t10 at t10.org [mailto:owner-t10 at t10.org] *On Behalf Of 
> *Penokie, George
> *Sent:* Wednesday, April 15, 2009 11:03 AM
> *To:* t10 at t10.org
> *Subject:* Error in new power conditions model section
>
>  
>
>  
>
> The following new wording added to section 5.10.1 Power conditions 
> overview is not correct:
>
>  
>
> If any power condition timer in the Power Condition mode page is 
> enabled, then that timer shall be stopped on receipt of a command. On 
> completion of the command, all enabled timers shall be reinitialized 
> based on their Power Condition mode page values and then started.
>
>  
>
> That wording conflicts with the following wording in section 6.29 
> REQUEST SENSE command:
>
>  
>
> Upon completion of the REQUEST SENSE command, the logical unit shall 
> return to the same power condition that was active before the REQUEST 
> SENSE command was received. A REQUEST SENSE command shall not reset 
> any power condition timers.
>
>  
>
> The wording that should have been put into section 5.10.1 Power 
> condition overview should have been:
>
>  
>
> If any power condition timer in the Power Condition mode page is 
> enabled, then that timer shall be stopped on receipt of a command. On 
> completion of the command, except the REQUEST SENSE command  (see 
> 6.29), all enabled timers shall be reinitialized based on their Power 
> Condition mode page values and then started.
>
>  
>
>  
>
> Bye for now,
>
> George Penokie
>
>  
>
> LSI Corporation
>
> 3033 41st St. NW
>
> Suite 100
>
> Rochester, MN 55901
>
>  
>
> 507-328-9017
>
> george.penokie at lsi.com
>
>  
>
>  
>
>  
>