QA Action Item: ASCQ

[Jason Ng]

* From the T10 Reflector (t10 at t10.org), posted by:
* "Jason Ng" <Jason_Ng at sonic.com>
*
Hi All,
 
I agree with David on this point.  It would also help during software development to know the exact specific error being reported so we can identify the problem easier and quicker.
 
Regards,
Jason Ng
Sonic Solutions
 

	-----Original Message----- 
	From: owner-t10 at t10.org on behalf of David Burg 
	Sent: Mon 1/31/2005 8:35 AM 
	To: mtfuji5 at avc-pioneer.com; keiji_katata at post.pioneer.co.jp 
	Cc: T10 at t10.org 
	Subject: Re: QA Action Item: ASCQ
	
	

	* From the T10 Reflector (t10 at t10.org), posted by:
	* David Burg <dburg at nero.com>
	*
	Hi all,
	
	I feel confused by all existing error codes. I favor the new error code
	proposal
	from Katata-san.
	
	Best regards,
	
	David Burg
	-
	
	----------------------------------------------------------------
	Software Development
	
	Nero AG
	Im Stoeckmaedle 18
	76307 Karlsbad        email: dburg at nero.com
	Germany               http://www.nero.com
	----------------------------------------------------------------
	
	Quoting keiji_katata at post.pioneer.co.jp:
	
	> Hi all,
	> Here is my action item about ASCQ of Write command crossing Layer Jump
	> point.
	>
	> Question:
	> When single Write command is issued crossing the layer jump address, what
	> error code shall be reported?
	>
	> Proposals:
	>  Existing Error Code
	>       5/21/00: LOGICAL BLOCK ADDRESS OUT OF RANGE
	>       This shows that start address is correct, but range is not correct.
	>       5/21/02: INVALID ADDRESS FOR WRITE
	>       This shows that start address may not be correct, and range may not
	> be correct.
	>       5/24/00: INVALID FIELD IN CDB
	>       This shows that some field in CDB is not correct. What?
	>       3/0C/07: WRITE ERROR. RECOVERY NEEDED
	>       This shows that something is wrong. How to recover?
	>  New Error Code
	>       5/21/03:  INVALID RANGE FOR WRITE
	>       Creating new error code is too much?
	>
	> Which do you favor?
	>
	> Best regards,
	>
	> Keiji Katata
	> PIONEER CORP.
	
	
	*
	* For T10 Reflector information, send a message with
	* 'info t10' (no quotes) in the message body to majordomo at t10.org
	

*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org