task states?

[Mallikarjun C.]

* From the T10 Reflector (t10 at t10.org), posted by:
* "Mallikarjun C." <cbm at rose.hp.com>
*
All,

SAM-2 (clause 7.4) describes the states a task goes through
on a target.  

In the case of linked commands, as far as I can tell, each of the
commands goes through the same transitions.  So, it appears to
me that the states be called "command states".

Apologies if this is discussed earlier, a pointer would be appreciated.
If not, providing the reason behind the current terminology would help 
my understanding.

Thanks!
--
Mallikarjun

Mallikarjun Chadalapaka
Networked Storage Architecture
Network Storage Solutions Organization
Hewlett-Packard MS 5668 
Roseville CA 95747

*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org