Obsolete Change Active Partition (CAP) bit in SSC-2

[Dave Peterson]

* From the T10 Reflector (t10 at t10.org), posted by:
* "Dave Peterson" <dap at cisco.com>
*
Howdy All,

At the last SSC-2 working group meeting the subject of obsoleting the CAP
bit in the Device Configuration page (10h) was discussed. The preferred
method to change partitions is to use the LOCATE command. Obsoleting the CAP
bit will eliminate the complexity of MODE SELECT behavior for changing
partitions when applied to the Explicit Address model. Please investigate
and respond if you have any objections to obsoleting the CAP bit in SSC-2.

Thanks,

David Peterson
Lead Architect - Standards Development
Cisco Systems - SRBU
6450 Wedgwood Road
Maple Grove, MN 55311
Office: 763-398-1007
Cell: 612-802-3299
Email: dap at cisco.com

*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org