98-173r0 -- SAM-2 Revision 6 Notes

Gene_Milligan at notes.seagate.com Gene_Milligan at notes.seagate.com
Sat Jun 6 13:22:38 PDT 1998

* From the T10 (formerly SCSI) Reflector (t10 at symbios.com), posted by:
* Gene_Milligan at notes.seagate.com
<<code value: A one or a series of defined numeric values each representing
an identified and described instance or condition.  Code values usually are
defined to be used in a specific field (see 3.1.35).>>
     I do not understand this definition. It would be better starting "One
or more defined" but what is a code value that is not used in a specific

Delete the usually phrase in the field definition or (not preferred)
explain what the unusual cases are.

Regarding (2) the new definition is better and just needs some minor
editing (adding articles and changing one or two "to"s to "too").

<<Notification of an error condition encountered after command completion
shall be returned only to the initiator that sent the affected task.>>

     I think this should be either "task(s)" or "task or tasks". Is it
clear with some other wording what should be done if it is not clear which
or if any tasks were affected?


* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at symbios.com

More information about the T10 mailing list