[T10] Determining an SED Drive
olga.otte at hpe.com
Thu Apr 7 08:31:02 PDT 2016
Do we expect "drive not ready" or "Invalid command" check condition if drive is not spin up yet? I think I am getting timing issue and not sure what is expected behavior.
Olga Otte HPE
From: t10-bounces at t10.org [mailto:t10-bounces at t10.org] On Behalf Of Saha, Soumit
Sent: Thursday, April 07, 2016 7:35 AM
To: Amir Dagan1
Cc: T10, Reflector
Subject: Re: [T10] Determining an SED Drive
You have to send SPC trusted receive (IF-RECV) SCSI primary command with discovery payload and handle illegal requests if the drive is not an SED.
There are no vital data pages for SED specific attributes.
On 7 Apr 2016 12:39, Amir Dagan1 <AMIRDA at il.ibm.com<mailto:AMIRDA at il.ibm.com>> wrote:
Is there a "SCSI" way (non vendor specific) to tell whether a device is an SED one (Self Encrypting Drive)?
I do not mean by P/N etc., but a designated field in a logpage, inquiry, etc.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the T10