SES: Seeking clarification on Threshold Out/In diagnostic pages

Raj Divecha Raj.Divecha at dothill.com
Fri May 4 10:29:04 PDT 2012


Formatted message: <a href="http://www.t10.org/cgi-bin/ac.pl?t=r&f=r1205040_f.htm">HTML-formatted message</a>

Hi,
I searched the T10 emails for this but didn't found anything.
The SES spec is a bit ambiguous regarding which element types should be
included in the Threshold Out/In diagnostic page. A clarification would be
helpful.
The following are the excerpts from the 2r20 spec. Below each excerpt is my
comment. The questions are at the end of the email.
6.1.8 Threshold Out diagnostic page
The Threshold Out diagnostic page is transmitted to the enclosure services
process to establish threshold values for those elements that have limited
sensing capability (e.g., temperature sensors, uninterruptible power
supplies, voltage sensors, and current sensors).
My comment: this statement "possibly" suggests that this page includes only
those element types that support threshold.
The threshold control descriptor list contains a threshold control descriptor
for each type descriptor header in the Configuration diagnostic page (see
6.1.2).
My comment: this statement "strongly" suggests that this page includes all
element types, whether or not they support thresholds.
7.1 Element definitions overview, Table 60
My comment: shows which element type support thresholds and which not.
7.2.4 Threshold control element format
All fields in the threshold control element are advisory. The enclosure
services process shall ignore the contents of the threshold control element
for those elements that have no value to be compared with a threshold and for
those elements that do not implement the threshold function.
My comment: this statement suggests that threshold descriptors for even those
element types, that do not support threshold, are included in the Threshold
Out/In diagnostic page, however, the application client and the enclosure
services process (ESP) are supposed to ignore them.
7.3 Field definitions for all element types
My comments: this section does not describe the threshold descriptors for
element types that do not support threshold. Not even a generic descriptor
with 4 reserved bytes is defined.
If the readers are to assume that the threshold descriptors for even those
element types that do not support threshold are to be included in the
Threshold Out/In diagnostic pages, then they are also supposed to assume a
generic 4-byte threshold descriptors with all bytes as reserved as they are
supposed to be ignored by both the application client and the ESP.
If the readers are to assume that the Threshold Out/In pages should include
only those element types that support threshold then there is no question of
assuming a generic 4-bytes reserved descriptor and no question of ignoring
them.
Based on the above there are many "strong" points that indicate that the
Threshold Out/In pages include even those element types that do not support
thresholds and there are some "weak" points that indicate that they don't
include those element types.
Did the spec authors intended to include additional descriptors in the page
that will never be used?
Or were the Threshold Out/In diagnostic pages meant to be similar to the
Additional Element Status diagnostic page where in only a selected subset of
element types appear in these pages?
In my opinion the spec authors did not intend to include additional
descriptors in the page that will never be used and thus the Threshold Out/In
diagnostic page is similar to the Additional Element Status diagnostic page
where only a limited subset of element types appear in these pages. However,
I could be wrong, thus please clarify.
Thanks,
Raj



More information about the T10 mailing list