SFF8449.

Felton, Mickey mickey.felton at emc.com
Fri Aug 24 06:34:42 PDT 2012


Formatted message: <a href="http://www.t10.org/cgi-bin/ac.pl?t=r&f=r1208241_f.htm">HTML-formatted message</a>

Please take a look at Table 6 Page 22 in the SFF 8436, where it gives
tolerances, we either need to add that couple line table in SFF8449 or change
the numbers to the minimum 1.8-5%, 2.5-5%, 3.3-5% in table 5-9..
From: Hugh Curley [mailto:hcurley at indra.com]
Sent: Friday, August 24, 2012 9:17 AM
To: Felton, Mickey
Cc: T10 Reflector; Olawsky, Barry
Subject: Re: SFF8449.
Hello Barry,
The word MINIMUM cannot have a tolerance. For example if we have MINIMUM
voltage = 2 volts plus or minus 10 percent, the MINIMUM is really 1.8 volts.
The same is true of MAXIMUM.
Thank you,
Hugh Curley
On 8/22/2012 2:01 PM, Felton, Mickey wrote:
Barry-
In table 5-9 of the SFF 8449 specification it calls out a MINIMUM operating
voltage WITHOUT a tolerance, or a tolerance built into the minimum.
I was wondering if we all implied a nominal operating voltage instead in this
table and we need a tolerance, or do we need to adjust the numbers in the
table to add a tolerance? Or other such adjustment?
Thanks..
-Mick



More information about the T10 mailing list