Proposal posted: SAS-3 addition of POWER DISABLE

Felton, Mickey mickey.felton at emc.com
Thu Aug 16 14:39:01 PDT 2012


Formatted message: <a href="http://www.t10.org/cgi-bin/ac.pl?t=r&f=r1208161_f.htm">HTML-formatted message</a>

Alvin-
EMC agrees with the principal behind this proposal, but a few questions:
How long after stable 12V / 5V is the circuitry ready? Could it be asserted
while power is ramping up?
Does the input signal on the drive have any special edge or level
requirements?
Thanks!
-Mick
From: owner-t10 at t10.org [mailto:owner-t10 at t10.org] On Behalf Of Alvin Cox
Sent: Thursday, August 16, 2012 12:33 PM
To: T10 Reflector
Subject: Proposal posted: SAS-3 addition of POWER DISABLE
This proposal changes the functions of P1, P2, and P3 from 3.3V. The signal
assignment of these pins have been changed by other standards that intermate
with SAS connectors. Please review this proposal. The proposal may be
downloaded at:
  http://www.t10.org/cgi-bin/ac.pl?t=d&f=12-363r0.pdf
This proposal was introduced on the 8/16/12 SAS PHY call and will be the
first discussion item on the 8/23/12 SAS PHY call.
Abstract
This proposal documents the changes associated with the addition of POWER
DISABLE to SAS-3. This function provides a means for the SAS target device
with a SAS Drive plug connector or SAS MultiLink Drive plug connector to
remove D.C. power (+5V and +12V) from the drive circuitry when the power
disable signal is driven high by the system. The POWER DISABLE signal is
specified on P3. If POWER DISABLE is not supported, P3 shall be not
connected. P1 and P2 are shorted together to provide the same connection as
on SAS drives compliant with versions of the SAS standard previous to SAS-3,
and to be consistent with the recommended implementation specified by SATA
since P1 and P2 have been retired and P3 may implement DEVSLP. The functional
polarity of POWER DISABLE is consistent with DEVSLP if the DEVSLP function is
enabled.
 Extensive research was done prior to drafting this proposal with respect to
system implementation on P1, P2, and P3. No instances were found where
systems provided 3.3V power to these pins. Maintaining the connection of P1
to P2 provided the widest support of legacy implementations that used the
pins for functionality not specified by the SAS standard.
--
Alvin Cox
Seagate Technology, LLC
Cell 405-206-4809
Office 405-392-3738
E-Mail	alvin.cox at seagate.com



More information about the T10 mailing list