SPC-4 Protocol Specific Logical Unit mode page

Penokie, George George.Penokie at lsi.com
Wed Jan 7 07:24:32 PST 2009


* From the T10 Reflector (t10 at t10.org), posted by:
* "Penokie, George" <George.Penokie at lsi.com>
*
Mike,
Thanks for pointing this out. I have submitted a T10 proposal to fix it as
you suggested.
Bye for now, 
George Penokie
LSI Corporation 
3033 41st St. NW 
Suite 100 
Rochester, MN 55901
507-328-9017 
george.penokie at lsi.com
-----Original Message-----
From: owner-t10 at t10.org [mailto:owner-t10 at t10.org] On Behalf Of Mike Berhan
Sent: Thursday, December 18, 2008 8:33 AM
To: t10 at t10.org
Subject: SPC-4 Protocol Specific Logical Unit mode page
* From the T10 Reflector (t10 at t10.org), posted by:
* "Mike Berhan" <mikeb at bustrace.com>
*
Advanced apologies if this has already been pointed out.
Page 444, Table 359, SPC-4 r17.  This table defines the Protocol Specific
Logical Unit mode page.  Offset 2, bits 7-4 are reserved.  Offset 3+ are the
protocol specific mode parameters.
Page 561, Table 221, SAS-2 r15 (same applies to SAS-1).  This table details
the SAS version of this mode page.  Note, however, that SAS defines bit 4
offset 2 as the "Transport Layer Retries" bit.
Reserved is well defined as:
3.3.8 reserved: A keyword referring to bits, bytes, words, fields and code
values that are set aside for future standardization. A reserved bit, byte,
word or field shall be set to zero, or in accordance with a future extension
to this standard. Recipients are not required to check reserved bits, bytes,
words or fields for zero values. Receipt of reserved code values in defined
fields shall be reported as an error.
The SAS specification conflicts with the SPC specification in this regard.
I believe SPC-4 should be amended to clarify this conflict.  Perhaps define
that one bit, or all four bits, as protocol specific as opposed to reserved.
Regards,
-------
Mike Berhan
busTRACE Technologies
9700 Village Center Drive
Suite 50-F
Granite Bay, CA  95746
916.773.4554 phone
916.218.6283 fax
http://www.bustrace.com
*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org
*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org



More information about the T10 mailing list