ADC-3: Add Port and Node Name to Fibre Channel Port Status Data (T10/08-226r0)

Paul Suhler Paul.Suhler at Quantum.Com
Mon May 5 22:45:20 PDT 2008


* From the T10 Reflector (t10 at t10.org), posted by:
* "Paul Suhler" <Paul.Suhler at Quantum.Com>
*
ADC-2 letter ballot comment HPQ-206 requested adding the Port_Name and
Node_Name to the Fibre Channel Port status data in the DT device primary
port status log parameter.  I have posted the following proposal to
address this request.
   http://www.t10.org/ftp/t10/document.08/08-226r0.pdf
Thanks,
Paul
___________________________________
Paul A. Suhler | Firmware Engineer | Quantum Corporation | Office:
949.856.7748 | paul.suhler at quantum.com
___________________________________
Disregard the Quantum Corporation confidentiality notice below.  The
information contained in this transmission is not confidential.
Permission is hereby explicitly granted to disclose, copy, and further
distribute to any individual(s) or organization(s), without restriction.
-----------------------------------------------------------
The information contained in this transmission may be 
confidential. Any disclosure, copying, or further 
distribution of confidential information is not permitted 
unless such privilege is explicitly granted in writing by 
Quantum Corporation. Furthermore, Quantum Corporation is not 
responsible for the proper and complete transmission of the 
substance of this communication or for any delay in its 
receipt.
------------------------------------------------------------
*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org



More information about the T10 mailing list