SPI4R10 Clarification (saved training config mode subpage)
Joel Baylon
Joel.A.Baylon at bitmicro.com
Tue Aug 23 00:59:22 PDT 2005
* From the T10 Reflector (t10 at t10.org), posted by:
* "Joel Baylon" <Joel.A.Baylon at bitmicro.com>
*
Hello,
I just need to clarify the saved training config mode subpage.
The SPI training sequences only shows the training of the REQ, ACK, DB,
P1, and PCRCA signals. But the saved training config mode subpage also
shows possible training config values for the RST, MSG, IO, etc... Are
these config values for future SPI standards only or is there also a
training sequence for the SCSI control signals?
Thanks!
Joel A. Baylon
Engineer
BiTMICRO Networks International, Inc.
45550 Northport Loop East
Fremont, CA USA
T: 510.743.3157
E: joel.a.baylon at bitmicro.com
W: http://www.bitmicro.com
------------------------------------------------------------
CONFIDENTIALITY NOTICE
This email and any attached documents may be confidential
and property of BiTMICRO Networks, Inc. If you are not the
intended recipient, you may not disclose, copy, distribute,
or act in reliance on the information in this email.
Also note, this email and attached documents are scanned for
the presence of virus. Changes made to this email after it
has been sent is not the responsibility of BiTMICRO Networks, Inc.
*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org
More information about the T10
mailing list