SAS Fill Byte Rules
Elliott, Robert (Server Storage)
Elliott at hp.com
Wed Sep 11 13:51:52 PDT 2002
* From the T10 Reflector (t10 at t10.org), posted by:
* "Elliott, Robert (Server Storage)" <Elliott at hp.com>
*
Everyone agrees that's the intent, although the text of SAS doesn't say that (it should have in the initial release).
02-318 proposes the changes to fix it, and is being revised again for an upcoming conference call. (it didn't pass this week)
> -----Original Message-----
> From: Dave Noeldner [mailto:daven at lsil.com]
> Sent: Tuesday, September 10, 2002 5:09 PM
> To: T10 Reflector
> Subject: SAS Fill Byte Rules
>
>
> * From the T10 Reflector (t10 at t10.org), posted by:
> * Dave Noeldner <daven at lsil.com>
> *
> Hi,
>
> I thought I remembered that the working group had decided on the rules
> for fill bytes and voted to include those in the SAS
> standard. However,
> I cannot find them in the latest SAS draft. Can someone
> please point me
> to where they are in the draft if they are included? If they are not
> included in the draft, can someone tell me if my interpretation is
> correct?
>
> I thought that fill bytes were not allowed for any frame unless it was
> the last frame of the command sequence. For data frames this
> would mean
> all frames had to be multiples of 4 bytes until the last data frame of
> the command. The frame sizes could vary on any frame, but
> they could not
> use fill bytes until the last frame.
>
> Thanks,
> Dave
>
> --
> / Dave Noeldner Office: (970)206-5792 \
> \ Design Engineer - LSI Logic Fax: (970)206-5244 /
> / 2001 Danfield Court http://www.lsil.com \
> \ Fort Collins, CO 80525 dave.noeldner at lsil.com /
>
> *
> * For T10 Reflector information, send a message with
> * 'info t10' (no quotes) in the message body to majordomo at t10.org
>
*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org
More information about the T10
mailing list