COMRESET vs. COMWAKE after detecting a SATA device
pbashfor at lsil.com
Thu Oct 24 15:45:27 PDT 2002
* From the T10 Reflector (t10 at t10.org), posted by:
* "Bashford, Patrick" <pbashfor at lsil.com>
In Section "6.6.3 SAS to SATA phy reset sequence" (in rev 2b), there is the
Either response indicates to the SAS phy that a SATA phy is attached. As a
result the SAS phy shall initiate a
SATA reset sequence (i.e., transmit a COMRESET).
However, Figure 46 shows transmission of a COMWAKE after the COMSAS Detect
Is the SAS phy required to restart the entire SATA reset sequence as implied
by the comment, or
is it allowed to continue with the COMWAKE as shown in Figure 46?
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org
More information about the T10