iscsi : changes involving tgt portal group tag.

Santosh Rao santoshr at cup.hp.com
Fri Mar 1 18:02:54 PST 2002


* From the T10 Reflector (t10 at t10.org), posted by:
* Santosh Rao <santoshr at cup.hp.com>
*
All,

I believe iscsi needs to make 2 changes :

1) to mandate persistence of the portal group tag (and thus, persistence
of its scsi target port identifier). 

2) to send the portal group tag (scsi target port identifier) as a part
of the iscsi login request.


The rationale for (1) is :
--------------------------
SAM-2 requires scsi port names to be persistent and world-wide-unique.
(SAM-2 Rev 22 Section 4.7.7). Quoting from SAM-2 :

"A scsi port name shall never change and may be used to persistently
identify a scsi initiator port or target port...".

iscsi defines scsi target port name as :

iscsi target name + NULL delimiter + 't' + NULL	+ (0 - 3) bytes of NULL
padding + 2 byte portal group tag (in big endian format).

In order for the above scsi target port name to meet SAM-2's requirement
of being persistent, the portal group tag needs to be persistent.


The rationale for (2) is :
--------------------------
Consider an initiator node establishing multiple sessions to a scsi tgt
port, with each session established to a subset of the network portals
within the tgt portal group. 

Consider an iscsi transport event involving the re-configuration of
target portal groups on the iscsi target node. This may be preceeded by
the iscsi sessions seeing an async message "target requests logout",
followed by session logout, portal group re-configuration, and then, the
initiator re-establishes sessions.

Across a transport event that results in such session termination and
re-establishment, the initiator needs to authenticate that it is still
speaking to the same [i]scsi target port, in order to ensure that any
open/active I-T-L nexus traffic on that session is not incorrectly
routed to a wrong LUN after such a transport event.

Note that the session end-points in such sessions  are individual
network portals within a portal group (tgt port) and a target
re-configuration involving the moving of network portals from 1 portal
group to another can occur.

Following such a re-configuration, if an initiator were to re-establish
a session to the same session end-points, since there is no addressing
information carried in the iscsi login request which carries the target
port identifier, the session may be established to the same network
portal, but under a different scsi target port and the I-T-L nexus
traffic incorrectly routed to a different scsi tgt port, resulting in
potential data corruption.

Other session oriented SCSI transports like FCP and SRP address this
problem by defining authentication schemes as well and/or explicitly
carrying the target port identifier in their login requests, which allow
them to identify such an authentication mis-match.

To prevent such authentication issues, iscsi can send the iscsi target
port identifier (portal group tag) explicitly in the login request, and
the login can be rejected by the target on a portal group tag mis-match.
(if the network portal does not belong to the addressed portal group
tag).

Also, on any portal group re-configuration, iscsi targets MUST terminate
the session to avoid such scenarios as described above.

Comments ?

Regards,
Santosh




-- 
##################################
Santosh Rao
Software Design Engineer,
HP-UX iSCSI Driver Team,
Hewlett Packard, Cupertino.
email : santoshr at cup.hp.com
Phone : 408-447-3751
##################################
*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org




More information about the T10 mailing list