About MMC Send Event

keiji_katata at post.pioneer.co.jp keiji_katata at post.pioneer.co.jp
Wed Jul 25 01:33:52 PDT 2001


* From the T10 Reflector (t10 at t10.org), posted by:
* keiji_katata at post.pioneer.co.jp
*



Hello Xin Li and all,

1. This should be error of document.

2. If unit supports Class 3 Event, the unit shall support Send Event
command. Please refer to Fuji5r13.pdf on page 237. This is original
proposal document and available at <ftp.avc-pioneer.com>.

About OP code, mmc3r10a.pdf 7/12 also has 5Dh.

I propose that Bill chairman of MMC3 should discuss these issues in the
next meeting or should fix document as well.

Best regards,

Keiji Katata
PIONEER CORP.




to:   t10 at t10.org

cc:    (bcc: Keiji Katata/Pioneer)
subject:  About MMC Send Event


* From the T10 Reflector (t10 at t10.org), posted by:
* XinLi at oaktech.com
*
Hi,

I have some questions about MMC2 command SEND EVENT (A2h). Could someone
there help? Thank you in advance!!!

My questions are:

1. In the Specification (NCITS 333, T10/1288D version 11a, August 30,
1999), In the SEND EVENT command description,  it says that" Only events of
Class External Request (Class 3) shall be sent via SEND EVENT command"(page
268) . But in the Event Parameter Header(page 269), the field 'Notification
Class" was set to 1h(3bits field). By definition(page 146), the 1h Class is
"Operational Change Request/Notification" class. it conflict with the
command description.

2. SEND EVENT is mandatory command for ATAPI device (page 303), but not all
ATAPI device have front panel with Play, Pause, Rewind, etc. How this
command be implemented without the Class 3 event at all?

By the way, the command op code was wrong in the CDB on page 268. It should
be A2h, not 5Dh. It was also wrong in the MMC 3 Specification( NCTIS XXX
T10/1363-D, revision 09, march 7, 2001).

Thank you!

Xin Li
Senior Firmware Engineer
Oak Technology, Inc.
139 Kifer Court
Sunnyvale, CA 94086
Tel: (408)616-6127
Fax: (408)523-6524
Email: Xinli at oaktech.com




*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org




*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org




More information about the T10 mailing list