SPC-2 Normative reference

Ralph Weber ralphoweber at compuserve.com
Fri Jul 13 13:27:04 PDT 2001


* From the T10 Reflector (t10 at t10.org), posted by:
* Ralph Weber <ralphoweber at compuserve.com>
*
ANSI/IEEE 394-1995 is the EUI reference used in the published SPC
standard.

This says that in 1997 it was a published ANSI standard.  If it
no longer is any catalogs, then it must have been withdrawn.

Thanks.

Ralph...

Peter Johansson wrote:

> Ralph (et al), what is ANSI/IEEE 394:1995, Extended Unique Identifier,
> 64-bit (EUI-64), cited in SPC-2 clause 2.2? I can't find any reference to
> it at http://standards.ieee.org/catalog/numeric.html. There's an IEEE Std
> 393-1991 and an IEEE Std 398-1972---but no IEEE Std 394-1995.
>
> Is it possible that the intended reference is to IEEE Std 1394-1995, High
> Performance Serial Bus? That standard defines EUI-64 in clause 8.3.2.5.7.1.
> If so, please correct both the numeric designation and the title.


*
* For T10 Reflector information, send a message with
* 'info t10' (no quotes) in the message body to majordomo at t10.org




More information about the T10 mailing list