From: Bill.Martin@emulex.com To: <Martin.Schulze@wdc.com> CC: <t10@t10.org> Date: Fri, 21 Nov 2008 10:51:26 -0800 Subject: RE: SAS transition from SP12 to SP0 X-Message-Number: 9339 Formatted message: HTML-formatted message Martin: The issue here is that if you are not connected to a SAS device, you will transition to SP1, and there you will have to wait for a hotplug timeout before you re-enter SP0 and transmit a COMMINIT. At that point, hopefully both devices will be in sync and they will both detect COMMINIT/COMWAKE appropriately and continue. If the COMMINIT detected was passed into SP0 you would avoid this hotplug timeout. Bill Martin Emulex Office of Technology Industry Standards 916 772-3658 916 765-6875 (Cell) bill.martin@emulex.com From: Martin Schulze [mailto:Martin.Schulze@wdc.com] Sent: Thursday, November 20, 2008 3:38 PM To: Martin, Bill Cc: t10@t10.org Subject: RE: SAS transition from SP12 to SP0 >From my reading of the standard, I do not believe the SP machine needs to remember that receiving a COMINIT is what brought it to SP0. Nor does it need to receive a COMINIT in SP0:OOB_COMINIT. Sending a COMINIT in SP0 and then both sending and receiving COMSAS (in other states) is sufficient to bring the bus to the start of SNW1. Martin Schulze Western Digital ________________________________ From: owner-t10@t10.org [mailto:owner-t10@t10.org] On Behalf Of Bill.Martin@Emulex.Com Sent: Thursday, November 20, 2008 3:18 PM To: t10@t10.org Cc: Shiro.Suzuki@Emulex.Com Subject: FW: SAS transition from SP12 to SP0 I have not seen a response on this, does anyone have any input on the original intent on this transition? Thanks, Bill Martin Emulex Office of Technology Industry Standards 916 772-3658 916 765-6875 (Cell) bill.martin@emulex.com From: owner-t10@t10.org [mailto:owner-t10@t10.org] On Behalf Of Bill.Martin@emulex.com Sent: Monday, November 17, 2008 1:11 PM To: t10@t10.org; Elliott@hp.com Subject: SAS transition from SP12 to SP0 When a SAS device is in the SP12::SAS_AwaitSNW, receives a COMINIT, and transitions to the SP0:OOB_COMINIT, shall the device remember that it has detected COMINIT or shall it wait for another COMINIT to be received? There is no mention of carrying a state variable forward to the SP0 state. Thanks for any and all opinions. Bill Martin Emulex Office of Technology Industry Standards 916 772-3658 916 765-6875 (Cell) bill.martin@emulex.com