I have a couple of isues with this.

1. The figure is a general figure for TxRx connections rather than specific to the test load. It should probably be in the TxRx section of chapter 5.

2. Although the pdf file describing how the 10-meter cable was measured is informative, the s-parameter zip file is normative and required for simulations used to test the transmitter and receiver.

It will be on the agenda for discussion.

Alvin Cox
Seagate Technology, LLC
Office 405-381-8067
Cell 405-206-4809
E-Mail alvin.cox@seagate.com

"Penokie, George" <George.Penokie@lsi.com>
No Phone Info Available

07/23/2008 08:53 AM

To	"T10 Reflector (t10@t10.org)" <t10@t10.org>
cc	"Fromm, Galen" <Galen.Fromm@molex.com>, "Alvin.Cox@seagate.com" <Alvin.Cox@seagate.com>
Subject	Proposal to replace the reference to 07-193 in SAS-2 with an annex

This is a re-creation of 07-193r1 putting it into a form that can be placed into the SAS-2 standard as an informative annex. If you have any comments let me know. I suspect it will be high on the agenda for the next SAS-2 phy call.

Your PDF file will be posted at:

http://www.t10.org/ftp/t10/document.08/08-312r0.pdf

Bye for now,
George Penokie

LSI Corporation
3033 41st St. NW
Suite 100
Rochester, MN 55901

507-328-9017
george.penokie@lsi.com