To: t10@t10.org Subject: Re: Proposal to replace the reference to 07-193 in SAS-2 with an annex From: Alvin.Cox@seagate.com Date: Wed, 23 Jul 2008 10:16:41 -0500 X-Message-Number: 8972 Formatted message: HTML-formatted message I have a couple of isues with this. 1. The figure is a general figure for TxRx connections rather than specific to the test load. It should probably be in the TxRx section of chapter 5. 2. Although the pdf file describing how the 10-meter cable was measured is informative, the s-parameter zip file is normative and required for simulations used to test the transmitter and receiver. It will be on the agenda for discussion. Alvin Cox Seagate Technology, LLC Office 405-381-8067 Cell 405-206-4809 E-Mail alvin.cox@seagate.com "Penokie, George" <George.Penokie@lsi.com> No Phone Info Available 07/23/2008 08:53 AM To "T10 Reflector (t10@t10.org)" <t10@t10.org> cc "Fromm, Galen" <Galen.Fromm@molex.com>, "Alvin.Cox@seagate.com" <Alvin.Cox@seagate.com> Subject Proposal to replace the reference to 07-193 in SAS-2 with an annex This is a re-creation of 07-193r1 putting it into a form that can be placed into the SAS-2 standard as an informative annex. If you have any comments let me know. I suspect it will be high on the agenda for the next SAS-2 phy call. Your PDF file will be posted at: http://www.t10.org/ftp/t10/document.08/08-312r0.pdf Bye for now, George Penokie LSI Corporation 3033 41st St. NW Suite 100 Rochester, MN 55901 507-328-9017 george.penokie@lsi.com