Subject: Latest iADT Proposal Uploaded Date: Fri, 13 Jun 2008 16:14:16 -0700 From: "Paul Suhler" <Paul.Suhler@Quantum.Com> To: <t10@t10.org> X-Message-Number: 8864 Formatted message: HTML-formatted message I have uploaded the latest version of the iADT proposal for discussion at next Wednesday's ADI working group teleconference: http://www.t10.org/ftp/t10/document.07/07-469r5.pdf The major changes are: * Enhanced model section. * Removed LED connections from ADT Ethernet bus description. * Added descriptions of LED blinking. * Specified a fixed TimeoutACK in seconds for ADT TCP connections. * Deleted ADT UDP interconnect. I tried to map the various protocol layers to the OSI model, but because the ADT Link Layer could be mapped at one level for ADT serial and at another for ADT TCP, I was concerned that this might be more confusing than helpful. Please take a look at the new layer figure and let me know what you think. Thanks, Paul ___________________________________ Paul A. Suhler | Firmware Engineer | Quantum Corporation | Office: 949.856.7748 | paul.suhler@quantum.com ___________________________________ Disregard the Quantum Corporation confidentiality notice below. The information contained in this transmission is not confidential. Permission is hereby explicitly granted to disclose, copy, and further distribute to any individual(s) or organization(s), without restriction. ----------------------------------------------------------- The information contained in this transmission may be confidential. Any disclosure, copying, or further distribution of confidential information is not permitted unless such privilege is explicitly granted in writing by Quantum Corporation. Furthermore, Quantum Corporation is not responsible for the proper and complete transmission of the substance of this communication or for any delay in its receipt. ------------------------------------------------------------