Jim,

I am confused with your proposal.  I cannot figure out what is to be filled in to the SECURITY PROPERTIES field.  I tried following the definition, but the reference in Table 193 does not specify anything about what to put in this field.
The contents of the SECURITY PROPERTIES field depend on the protocol specified by the least significant byte of the SECURITY PROTOCOL SPECIFIC field (see table 193). The contents are defined by the related reference in table 194.
I assume it is your intent to define in each of the security protocols what is to be placed in this field.  However, without an example I do not understand what properties you are intending to specify and how multiple protocols relate.

Thanks,

Kevin D. Butt
SCSI & Fibre Channel Architect, Tape Firmware
MS 6TYA, 9000 S. Rita Rd., Tucson, AZ 85744
Tel: 520-799-2869 / 520-799-5280
Fax: 520-799-2723 (T/L:321)
Email address: kdbutt@us.ibm.com
http://www-03.ibm.com/servers/storage/