From: Ramez.Rizk@emulex.com
Subject: Transmitter Device Source Termination
Date: Wed, 22 Feb 2006 10:06:59 -0800
To: <t10@t10.org>
X-Message-Number: 6647
Formatted message: HTML-formatted message

Hi all,
I was looking at the SAS 2 draft Table 44 page 153 and SAS 1.1 Table 43
page 149.  In both drafts note b for the measurements requirements says
the following:
"All transmitter device termination measurements are made through mated
connector pairs" 
This does not make any reference to the IT compliance point, which makes
me believe that it can be done with any connector type as long as they
are mated, for example SMA mated pair.	Is that assumption correct? If
not, I think we need to clarify it more in the standard.
Thanks
Ramez